Thread: skunk2 short throw shifter!!!???
View Single Post
  #18 (permalink)  
Old 07-26-2007, 07:19 PM
Illusive's Avatar
Illusive Illusive is offline
Administrator
iTrader: (3)
  
Join Date: Apr 2006
Location: Calgary, AB, Canada
Posts: 4,954
Rep Power: 1545347
Illusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to liveIllusive relies on Rep Points to live
Send a message via MSN to Illusive
Here is a good question...what if I coupled my Mugen SS with this? Would that make it even shorter?!?! I mean theoretically, it should do the same thing with the Mugen SS. The assembly is the same, but Mugen shortened it by shortening the whole shifter and providing the assembly with it. With this on the Mugen one, you can shorten your shifts by a lot!!! Mechie Engg senses tingling

Or am I just out to lunch with this one?!?!?

Do you guys provide the extra clamp etc. for the install since you need to pry that bugger off as well as that clip looking thing to get underneath the shifter?
__________________
Last edited by Illusive; 07-26-2007 at 07:24 PM.
Reply With Quote