as per request, will do a write up on my quick JDM front end conversion
JDM HID Headlamps
JDM Fenders
JDM Bumper (Mugen Prof) series used
JDM rebar (remodified)
JDM Sized Carbon Fibre Hood
Removed items:
Lower Extended Engine cover
North American Fenders
North American Bumper
North American Front Rebar
North American Headlamp
North American Hood
North American Hood Latch holder
Modified items:
Relocated Hood Latch
Slight bendage on the rad support to allow JDM Headlamp to fit
Cut out for relocation of Hood Latch on rad support (by doing this, there is no need to replace to the JDM Rad Support)
Apart from the list above I think that is about it?
The way that I partook is probably a quick short cut way instead of replacing the rad support and in my mind I think it is the cheapest route to go
As for the rear:
used
JDM sized Mugen Fitted rear bumper
JDM sized Mugen Trunk Finisher
Removed
North American Rear Bumper
North Amiercan Re-Bar
Let me finish off my BBQ here and will see what else I forgot!