Thread: Attn - anyone who has made a Turbo manifold for the L15A
View Single Post
  #13 (permalink)  
Old 07-08-2009, 10:49 PM
underdog underdog is offline
Member
iTrader: (2)
  
Join Date: Mar 2008
Location: Mesa, AZ
Posts: 330
Rep Power: 859095
underdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to liveunderdog relies on Rep Points to live
just a few things to consider.

one:make sure you put the flange on before you start welding on it. it will only go on one way. not symetrical although it looks like it is.

two: don't get stainless steel weld el's unless you have a proper welding setup for stainless. sch 10 works fine for SS but you may want to go with sch 40 el's if your going the mild steel approach.

three: don't rush it! and realize it's going to take alot of man hours. don't think your going to whip it out in a weekend. because you will run into all the "little shit" that kills you. lol
__________________
2008 SSM Tanabe GF210 springs, Tanabe front strut bar, progress rear sway bar, Drag dr21's gunmetal, S2 short shifter & knob, Mishimoto intake, 8k hids, 4.3k fog's.


Reply With Quote