Hey your blog helped ALOT thanks. However when i did my front one, the emblem wouldnt stick very well. Maybe the plastic was too slippery after i sanded that part down on the grill??? But what i did was i found some construction adhesive in the garage and put a little bit on the emblem and then just pushed it onto the spot on the grill and let it set up. It sure isnt going anywhere now. The crap said it was waterproof and i assume they use it outdoors all the time if its used in construction so what do you think? Think it will last? Thanks!
great stuff!
Just installed it a few minutes ago using this DIY and all was good.
Just hated the whole sanding the front part. Just a warning to everyone, to remember to protect the car with a towel or something cause I made small scratch marks when sanding that front grill without knowing it until it was too late.
Now, I just hope it stays on. My first test will be when I give the car a wash.
i installed the rear h i had to sand the hell out of the pin stub to cause had the stub on my car where the emblem was.. that was wack. hope when i instal the fron would be all g
anybody used some type of glue or epoxy along with the doubled sided tape ? ... i live in an area of orlando where car thieves run rampant and i want to prevent a potential ass whooping to some poor thief ricer ? any suggestions other then park it inside the garage ?
__________________
0o0o0 yeaaa gettin rid of my stock wheels.... for other stock wheels
Linear Mode
