Foglight cut-out template for Base Model install

ImPuLsIvE.ca · #1 (**permalink**) 10-06-2008, 09:10 AM

Hey,

I've purchased some OEM Honda foglights and have downloaded all the instructions for a nice DIY project. However, the only thing I'm missing are the templates for cutting the bumper properly. I guess they forgot to add them to the shipping package

.

Does anyone know where to get the templates so I could print them off?

Any information would be greatly appreciated.

Thanks!

ImPuLsIvE.ca · #2 (**permalink**) 10-06-2008, 02:02 PM

No one has this?

Is there anyway to cut the bumper without them then?

Tomy12 · #3 (**permalink**) 11-18-2008, 12:17 AM

i just bought a brand new foglight kit, when i get my hands on it, i'll see if it comes with the template for ya

Tomy12 · #4 (**permalink**) 12-01-2008, 03:22 PM

i opened the box and there is a template inside, I can scan it for you.. let me know if u still need it.

loicf · #5 (**permalink**) 10-29-2009, 08:57 PM

I just got this kit too. I don't got the template. Is there somebody here that can scan?

Thank you!

Kishore · #6 (**permalink**) 11-07-2009, 11:52 PM

Quote:

Originally Posted by loicf

I just got this kit too. I don't got the template. Is there somebody here that can scan?

Thank you!

Did you get the template. I have one can look for it if required

loicf · #7 (**permalink**) 11-09-2009, 07:32 AM

Thank you kishore but I done this job this week-end.

If anyone is in same situation I was, even without template it's fairly easy to do.

The most important side to take care is the external side. I left half on inch at left and right side and about 1/8 on the upper and down side. I cut all with a rotary saw on a dremel. Watch out, when the saw become worn, it bite on the material so take it with 2 hand and protect other surfaces of the bumper. It happen to me, I done a 6inch scratch on the bumber ouch!

I forgot my camera when I was at garage but next time I will take some pics.

Thank you,

LF