Fit Interior & Exterior IlluminationThreads discussing interior and exterior lighting modifications for the Fit/Jazz
Welcome to Fit Freak!
Welcome to Fit Freak,
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
I needed to replace my license plate bulbs and decided to attempt such an act.
I was reading on the forums of the horror stories that other Fitfreaks had when removing the bulb cover, evidentally it's very very fragile.
So I figured I'd give it a try and when I followed the Honda directions (push the cover to the right), it came out with a little pressure, but so did the locking mechanisms that it uses.
So apparently, to Honda, in-order for one to remove these bulb coverings - they have to destroy them!?
I can't understand this, but now I have my license plate bulb coverings held in place by masking tape...
Does anyone have a remedy to this situation other than the extremely make-shift one I have right now?
Should I complain to Honda for this ridiculous in-justice?
Am I over-reacting? I mean - I follow the OEM instructions to remove the cover and it results in the destruction of the cover!
Do you think Honda would re-imburse this?
If anyone has any similar stories / remedies, please share!!
Thanks.
__________________ I love my Honda Fit.
Sponsored Links
Registered users do not see this ad. Click here to register for free!
I didn't read your post, but yeah, those things are weak. I suggest taking off the inside trunk panel off in order to access the bulbs without risk of breaking the housing
yep i broke mine too. only the right side. i did take it backk to the dealer and he replaced it under warranty. what i did when it was broken( it was going to rain that night) was i took plastic wrap and put it around the unit, then i took two plastic bags and cut the corners off to leave a triangle about 4 inches by 4 inches then pup the unit into the corner of the bag, wraped the edges around back then stuffed the unit back in. the plastic acted as the clip that broke off. and it stayed in untill i got my new part, with out any tape. and it was moisture retardnt. This was done with LED,s in place of bulbs. i think the heat from a bulb would be to hot. i hope this helps
__________________
---present mods 09 fit blue pearl----- vinyl grafix- ivtec sohc,bottom rear doors(large text)
Tint- 38% two front small windows with chrome "h" logo, 38% front driver/pass, 20% on the rest
Leds-front running lights, licenceplate lights,blue dome light w/ two leds, breaking tail lights
Head lights- cool blue
lower grill guard
interior strobe lights
vm9022 headunit w nav 101
PS2
Next mods-hitron 1000.1 amp, jensen pro 12 inch sub in a custom glassed box, e2 1 farad cap