has anyone here installed a HID foglights? can someone help me cuz i got one but i cant seem to figure it out hehehe i tried searching for a DIY but no luck.
thanks!
__________________
i only used the brake so i can accelerate all over again...
do hids feel any hotter on the fogs?i had the yellow film on the fogs and replaced the bulbs with the yellow nokya ones and they burned them(film) cause the got too hot.
does anyone know where i would connect this? i know its for the ground but im not sure though... can anyone help me.. specially those with xenith fogs installed.. any help will be greatly appreciated hehehe
i connect the other end to the ballast but i dont know where to put the other end...
__________________
i only used the brake so i can accelerate all over again...
does anyone know where i would connect this? i know its for the ground but im not sure though... can anyone help me.. specially those with xenith fogs installed.. any help will be greatly appreciated hehehe
i connect the other end to the ballast but i dont know where to put the other end...
one goes to the hot side of your factory harness and the other goes to the ground side. best thing to do is pull the factory bulb and use a test light and switch fogs on to find which is power and ground.
i am having the same problem. i got my h4 kit on in less than 30 minutes. i know how the system is supposed to be wired but the metal spades dont fit into my factory harness. is there something that im not doing right? are the spades supposed to just slide in? because the ones supplied with my kit are about twice the size of the sockts on the factory harness.
they should just slide in, check to see if any of the slots are different sizes, i just tried different slots until they worked. its not going to hurt anything if you hook them up backwards they just wont work.
they should just slide in, check to see if any of the slots are different sizes, i just tried different slots until they worked. its not going to hurt anything if you hook them up backwards they just wont work.
i actually figured it out last night after work. the spades were to big to slide into the stock harness so i filed them down so they would fit. it took me like ten minutes doing it with a little nail file i found in my garage. but i got them hooked up and running.
so you just file those 2 metal thingie and slide it into the harness from the stock fogs? can you post a pic of it.. just curious. maybe i can do it on mine
__________________
i only used the brake so i can accelerate all over again...
so you just file those 2 metal thingie and slide it into the harness from the stock fogs? can you post a pic of it.. just curious. maybe i can do it on mine
yea ill try to get some pics up for you by the end of the night.