Fit Photos & VideosThreads for displaying photos and videos of the Honda Fit/Jazz
Welcome to Fit Freak!
Welcome to Fit Freak,
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
looks good, new wheels? now you jsut need to lower her a bit.
Wheels I got last september. Added some MTEC bulbs, Honda OEM rear bumper appliqué and muffler tip and of course Mugen ventilated visors.
And yes, lowering it might be next. By the way, nice Fit MN...
That looks realy sexy with no wiper/emblem. How easy is it to change out that panel? I do kind of need to keep my wiper but getting ride of the emblem would look nice.
it was simple because I have the 2007 shop manual lol. Basically:
use a flathead and pry the two things off their hooks (the pull handle you use to close the rear hatch), pull out the pull handle. Using same flathead, push the little circles on the 2 clips next to the pull handle and pull them out. Start pulling down and around to undo the inside panel clips. Take off the wiperblade and the little piece to expose the 10mm nut. Unclip the wiper motor harness, unbolt the 3 bolts keeping the motor secured. Unbolt the 10mm nut on the outside to let the motor fall out (have one hand inside holding the motor and one hand unbolting the nut on the outside). Remove the rubber wiper grommet thing. Unbolt the main bolt keeping the existing garnish attached. Push the 2 black clips and 3 white clips up and out to push the garnish off. Now take ikona's garnish, take off the washers/nuts he provides, slide all the screws into the holes. Make sure the rubber underneath the rear glass goes over or flush with the garnish. Don't let it get pinched. Use a flathead carefully to pull the rubber out if that happens. Put the washers/nuts on tightly, I think they were 8 or 9mm. Then put the big inside panel back on (press so all the clips pop back in). Then reinstall the pull handle by just sliding it in til it clicks. Boom, all done! Sorry I don't have pics to explain. I'll take pics of the shop manual instructions when I get around to it. Hope that helps!
__________________
For Sale:: Progress swaybar, Weapon R trunk cage, right FX35 retrofit headlight. PM with offer if interested