As usual, AJR, Fitfreak.net nor I (Fit of RAGE!) is responsible for ANY damages, problems to your vehicle. Please be EXTREMELY cautious and
perform this mod at your own discretion.
I kinda got carried away and ended up in "the Zone" when i was doing this so it's kinda a crappy DIY Anyway,
1) Purchase sway bar
2) Personally, i felt that taking the cat out is VERY useful, so remove cat
3) disconnect the sway bar from the link kits. You'll need an Allen head AND a 12mm wrench.
The reason you need to do this is that if you just use a 12mm, the link kit will most likely spin and you'll never get the bolt off.
4) support the vehicle front AND back as you'll need to drop the engine/tranny cradle a little
5) Unbolt the lower control arm. There are 3 bolts. two shown here and one in front.
6)
7) Now, unbolt the cradle from the car. there are 4 bolts in total. (two were from the control arm)
8) Unbolt the hold down bracket for the swaybar and lower the engine/tranny cradle just enough to get the swaybar out
9) Now, reverse the order. Make sure that you lube up the bushings REALLY well!!!
Linear Mode
