Depending on the amount of interest... I will do these for the general fit public. Currently I'm working on a set for a fitfreak member (front and rear CF door inserts in 2x2 carbon fiber) and here are pictures of progress. Note the carbon fiber looks dirty because it was straight out of the mold. No wet sanding or clear coat yet. I'm going to first do the other 3 before I trim and clear coat them. So it just does not look glossy. But the end product will have a super high gloss finish to them.
The price would be $350 for the front $300 for the rear or $620 for all four. Shipping would be $25 for all four or $20 for two. Tracking and insurance is on us.
If we get 3 people to purchase then you get free shipping.
5 people to purchase you guys get free shipping plus $20 off.
7 people is free shipping plus $40 off.
10 people is free shipping plus $60 off.
You can also get them unpainted (Front $200, rear $200)
Or Painted (Front $300, Rear $300)
I started by masking the front but then thought it was unnecessary since theres no way I can damage the front by cutting the back. The back of the panel had to be cut since the factory made the door panel as a one piece mold.
You can see I just cut in the center of that line and then grinded it down a little until I got far enough that the space opened.
The two rear panels out and trimmed
The mold was created - That was a very tricky and complicated task.
The carbon fiber was put up in the mold and then vacuum pressed so all the corners are tight and pushed in.
And the semi finished product
All the edges are perfect!
The group buy list would start here. All the molds are done but 1 so this could start as soon as you guys would like.
1.
2.
3.
4.
5.
Some people are like Slinkys; they can only make you laugh if you push them down a flight of stairs
(FitS)
(AWDcivicW)
Everybody enjoy your mondays! I see most of the US is lookin good as far as skys go!
Linear Mode
