lilaznphatboy's USDM -> JDM front and rear!!!!!!
#42
I guess one of the few that actually doesn't like the front end. It's too flat IMO. Looks like the bumper got smushed in. But nice job on the conversion none the less. It's very different and unique.
#48
yea it would have but hey they are done now. i had them on the ECHM but the clear coat didn't set right so imma have to wet sand them and reapply the CC again
#49
I'm planning to do a MDP (mexico domestic product) conversion (Mexico b/c shipping will be dramatically cheaper than Japan) on my GE Fit in the near future and the window pieces are holding me back.
#51
Second, question...did you happen to make a mold so that you could sell the window pieces?
I'm planning to do a MDP (mexico domestic product) conversion (Mexico b/c shipping will be dramatically cheaper than Japan) on my GE Fit in the near future and the window pieces are holding me back.
I'm planning to do a MDP (mexico domestic product) conversion (Mexico b/c shipping will be dramatically cheaper than Japan) on my GE Fit in the near future and the window pieces are holding me back.
yea man i was great meeting the guys from 757. next time you any of you guys are in the 804 or 703 area, lemme know
#52
Second, question...did you happen to make a mold so that you could sell the window pieces?
I'm planning to do a MDP (mexico domestic product) conversion (Mexico b/c shipping will be dramatically cheaper than Japan) on my GE Fit in the near future and the window pieces are holding me back.
I'm planning to do a MDP (mexico domestic product) conversion (Mexico b/c shipping will be dramatically cheaper than Japan) on my GE Fit in the near future and the window pieces are holding me back.
#59
When you are ready, I have some JDM Fit parts I will sell you...headlights and hood latch for cheap!