lilaznphatboy's USDM -> JDM front and rear!!!!!!
#61
I will sell both for $300 shipped....the headlights are mint and would cost you upwards of $500 by themself. The hood latch sells for upwards of $80. You can see this is a killer deal. Both are required for the ings kit.
#62
i'm just asking what is everything i need for the conversion. from there i may buy from you what i need
#65
Hello,
I had read your DIY thread on this JDM conversion,
Your Guidance for the FRONT Bumper is very good and comprehensive.
but
There is no guidance for us when you convert your REAR bumper to JDM version.
So if you don't mind, I have several questions for you,
Is the JDM REAR Bumper mounting (clip or screw) attached to the same mounting location?
Which part of the chassis/body that we need to CUT in order to install the REAR JDM Bumper?
Is the JDM REAR Bumper cut out for Exhaust Pipe match the USDM Exhaust Pipe location and Length (did the exhaust tips stick out)?
Please kindly explain what we need to do/modify to convert our USDM Rear Bumper to JDM REAR Bumper.
Thank You
Last edited by BMW ALPINA; 03-08-2013 at 01:25 PM.
#66
Major props on the conversion. I can't see myself dropping that kinda dough, but it looks great, and now you get to use all the cool Jdm pieces we can't use!
On a total side note, where'd you get those fitfreak decals? Mine ripped and was from dd, I like the way yours outlines anyhow.
On a total side note, where'd you get those fitfreak decals? Mine ripped and was from dd, I like the way yours outlines anyhow.
Thread
Thread Starter
Forum
Replies
Last Post