Got -1.8 camber just from 1 SPC bolt only!
So was reading on the forum and noticed most folks complained using only a single SPC camber bolt the most they were able to get was around -1.0 camber.
So shockingly, my alignment shop told me they were able to get -1.8 up fronts with no problems at all with just swapping out a single strut bolt with the SPC. My info: 2013 GE8 Base swift springs Progressive RSB 15x7 RPF1 w/ 205/50/15 BFG Rivals So wonder what all the fuss was about needing two SPC bolts to get anywhere near -2.0?:confused: |
They probably did the bottom bolt. Having the camber bolt up top is best for most angle
|
Nah ya got it wrong.
1.75 degress was the reported with one bolt. ~2.5 degrees was with two bolts. Some people are running 1 degree with one bolt and not maxing them out. Glad you got them in though, will be ordering mine tomorrow. :) |
i was wondering where could you get the max negative camber with bolts?
on the upper side of the strut or the lower ? or is it the same ? |
All times are GMT -4. The time now is 09:08 PM. |
© 2024 MH Sub I, LLC dba Internet Brands