Need help with spring install
I was able to remove the strut assembly from the car. The top nut that's holding the assembly won't come loose, It just spins together with the long bolt in the center. I was not able to remove the spring from the strut. Anybody here encounter the same problem? TIA.
|
I don't have direct experience with your model car, but there is usually a spot on the shaft that is not round where you can put a wrench on it to keep it from spinning.
If not, you'll need an impact. |
I got the 2015 EX 6 spd manual. I am gonna try again on my next day off, see if that works. Thanks BTW.
|
strut help
Maybe this could help. Allen wrench and wrench on nut,
https://cimg8.ibsrv.net/gimg/www.fit...1d5fdd4072.jpg James |
@ James Butler, I am passed this part, my problem is removing the top nut to separate the spring from the strut.
|
Like I said, I don't have direct experience with your model, but that should be the only nut that needs to be removed.
There should be three nuts that remove the assembly from the car and then that center nut allows disassembly of the spring and mount from the strut. Looks like you need an allen wrench. |
@GAFIT, I'll try that next time thanks.
|
Originally Posted by oiric2006@gmail.com
(Post 1399255)
I was able to remove the strut assembly from the car. The top nut that's holding the assembly won't come loose, It just spins together with the long bolt in the center. I was not able to remove the spring from the strut. Anybody here encounter the same problem? TIA.
|
I think I remember the part you're talking about, had to use an impact wrench. I don't do enough mechanic work to have quality air tools, but a 18v Ryobi from Home Depot that came with the drill I wanted had enough power to do the job.
|
Originally Posted by James Butler
(Post 1399263)
Maybe this could help. Allen wrench and wrench on nut,
https://cimg8.ibsrv.net/gimg/www.fit...1d5fdd4072.jpg James see figure C ... you need to shove an allen wrench in that hole to keep what is spinning to NOT spin .... once you achieve that.... NOW you can remove the nut |
Originally Posted by oiric2006@gmail.com
(Post 1399264)
@ James Butler, I am passed this part, my problem is removing the top nut to separate the spring from the strut.
|
I was able to take it off. Trick is to not use the spring compressor, I just use my ryobi 20 volts impact wrench and it did the trick. The springs didn't have much tension on it. i am not sure about others though. I tried everything and took a gamble, it worked. But my sway bar end links passenger side bolts has a loose thread. I was not able to do the passenger side. =(
|
I did 1st side with spring compressor, noticed theres not much tension. for the 2nd side, didnt use the spring compressor and it was fine
|
All times are GMT -4. The time now is 08:27 AM. |
© 2024 MH Sub I, LLC dba Internet Brands