J's Racing header
 

J's Racing just released their new header which will fit onto the USDM Fit. Stainless steel made with 28mm piping, 4-1 designed. J's Racing claims the header made 8hp (to the crank).

Available - End of Febuary

http://www.aj-racing.com/ajpwr/Fit/Js-header-GD3.jpg

http://www.aj-racing.com/ajpwr/Fit/S6000086.jpg

I have seen this prototype in person and it is very light and the welds are nice. Can wait wait to see the actual product :)

nice has an o2 bung. any idea on how much louder it is vs. stock? also approximate cost?

yes approximate cost would be good :) I am broke but I am addicted to modding my Fit! If it costs over 5 bills though (which is highly likely) I might have to save up for JR supercharger. It may cost a lot but will get you a lot of bang!!! N/A on L-series can only make so much power :(

Ben, I'm assuming this is the exact same header they've posted on their site, right? If so, are you going to be getting any of the thermal-wrapped versions?