I want to install my GF210's
 

This question is for my Florida people. Anybody know of a good installer that can install my springs for a fair price. Preferably in
the south florida area. Thanks!

just do it urself it's soooo easy!

I would but I don't have all the tools or the patience, lol....

You could pay for the tools with what you save by not paying a mechanic. I don't know about Florida, but around this area of CA, labor rates are about $100. per hour min., and that's for any part of an hour. When you do a job yourself, you learn new skills, save money, add to the tools that you may need in the future,and don't pay for someone else's mistakes. You will make mistakes, but just repeat the job until you get it right. You also learn patience, because you can't drive until you get it right

Worst case, if you REALLY f**k up, use your AAA card to tow the car to a mechanic, and THEN take the 50/50 gamble that HE knows what he's doing.

yeh and the tools that you need.... there's really not that much.

Hmmmm you guys make a good point. I'll look up the DIY thread and see what is exactly involved in dropping a fit. Which would be the best thread?

there was another forum that had a word doc how to... cant remember which site it was vtec.net or honda-tech or something.

but run a search on skunk2 springs here and i think someone did a diy.

how about locate a local fitfreaker in the FL area that can help you out. I bet there are lots that can spare some time to help ya out.