What kind of glue should I use inside my headlight housing?
1 Attachment(s)
Got some LED tubes im going to install inside my headlights but what kind of glue should I use. The LED tubes are a silicone rubber material looking to install it on my plastic black painted housing.
THX! |
don't use glue. drill some tiny holes and use either nylon string or jeweler's wire.
|
Originally Posted by xxryu139xx
(Post 1405833)
don't use glue. drill some tiny holes and use either nylon string or jeweler's wire.
im curious wouldn't the strings show? |
no unless u look real hard.
|
Originally Posted by xxryu139xx
(Post 1405837)
no unless u look real hard.
|
all these leds, halos, tubes, they all fail. if u glue them, there is no turning back. if u use wire, u can always remove it cleanly. and then redo if u must.
|
Tiny holes would allow moisture to get in would it not?
Silicon would hold it well and not be difficult to remove. |
u won't be drilling through the whole headlight. it will just be where the shroud/reflectors are which are contained inside the headlight.
|
Originally Posted by GolNat
(Post 1405845)
Tiny holes would allow moisture to get in would it not?
Silicon would hold it well and not be difficult to remove. |
All times are GMT -4. The time now is 04:56 AM. |
© 2024 MH Sub I, LLC dba Internet Brands