Fit 1/4 Mile Times
#61
Super good time again my friend, just for perspective I did a 15.3 in my old car (96 civic cx, B20Z swap (146 hp non vtec), ITR tranny/clutch/flywheel/lsd, AEM intake, stock pea shooter exhaust, middle of the summer temps). And that was with a 2.2 60ft!
So kudos to you, I hope to break the 15s in my GD with, weapon r race header, open header, weight reduction, CAI, vx wheels running 175/60r13 tires.
Unfortunately the headers are out of stock until Feb at the earliest...so i ordered a tanabe medallion touring for a subtle exhaust note on the daily commute.
So kudos to you, I hope to break the 15s in my GD with, weapon r race header, open header, weight reduction, CAI, vx wheels running 175/60r13 tires.
Unfortunately the headers are out of stock until Feb at the earliest...so i ordered a tanabe medallion touring for a subtle exhaust note on the daily commute.
Good luck! I have been reading up on your ride for a while now. I really like that car. I hope you get the times you are looking for.
#62
15.6@89mph Video
Last edited by Myxalplyx; 12-27-2014 at 08:44 PM.
#64
Grrrrr
Still to darn quiet here. Please share any new info on how you have been running at the dragstrip. Don't be embarrassed! Any information is good information for the community so we can share and take notes. I've been busy since the end of last year and a little this year. Hoping to gather some info from fellow racers and apply knowledge across the board on all models. Looking forward to any information, especially before and after making any changes, to any year Fit.
There's more testing to be done.
There's more testing to be done.
#65
I hope to make it to the 1/4 mile sometime this summer. I have been preparing for it, got my function & form type II coilovers installed, switched my stock seat out for a race seat (see link in sig). Need to update my weights list as the lighter seat will bring me to about 470 lbs reduction. Whenever the weapon r race header gets in (back ordered since the beginning of the year) I'll be all set to hit the track.
I see you are up to 15.2 now, that's great! Good driving.
I see you are up to 15.2 now, that's great! Good driving.
#66
Ran earlier tonight at Cecil County Raceway. Was testing full J's racing exhaust with Myxal SRI-CAI Ram-Air Intake. Temp was between 66F-70F.
5/22/15 Cecil County Dragway
15.504@90.62mph
15.484@90.86mph
15.445@90.15mph
15.448@91.03mph
15.465@90.27mph
15.448@90.31mph
These have been the most consistent runs I have done in a while. 1/4 mile speed and mph all stayed about the same. I've stretched both the intake and exhaust as far as I can go at the moment. I'm done testing configurations of both. Looking for other power mods now.
5/22/15 Cecil County Dragway
15.504@90.62mph
15.484@90.86mph
15.445@90.15mph
15.448@91.03mph
15.465@90.27mph
15.448@90.31mph
These have been the most consistent runs I have done in a while. 1/4 mile speed and mph all stayed about the same. I've stretched both the intake and exhaust as far as I can go at the moment. I'm done testing configurations of both. Looking for other power mods now.
Last edited by Myxalplyx; 05-23-2015 at 08:35 PM.
#67
Any new developments here? New times? Been too quiet here.
Thanks Devmail! I hope things worked out for you this summer. It's getting cool again so I'm at it to see how things go. I have a few tricks up my sleeve. I'll be happy with a 15.1 to be honest. Only way to know is testing. Hoping it all comes together this week or at least this month.
Thanks Devmail! I hope things worked out for you this summer. It's getting cool again so I'm at it to see how things go. I have a few tricks up my sleeve. I'll be happy with a 15.1 to be honest. Only way to know is testing. Hoping it all comes together this week or at least this month.
Last edited by Myxalplyx; 11-04-2015 at 03:40 PM.
#68
Forgot to update this post. Last August I ran a 16.0 at 84 mph with a 2.3 60 ft all motor, and a 14.8 at 97.8 mph with a 2.4 60 ft on a 75 shot. Only ran once on the bottle as I have no way to retard timing yet with that high of a shot. This coming August I will be running again with a direct port 60 shot and about 150 lbs lighter. Hoping the stock clutch holds the nitrous as I didn't get a new clutch/flywheel combo like i planned. One of these evenings I hope to weigh the car with all the weight out to have a ball park number in mind.
#69
Forgot to update this post. Last August I ran a 16.0 at 84 mph with a 2.3 60 ft all motor, and a 14.8 at 97.8 mph with a 2.4 60 ft on a 75 shot. Only ran once on the bottle as I have no way to retard timing yet with that high of a shot. This coming August I will be running again with a direct port 60 shot and about 150 lbs lighter.
Regardless! I love your progress.
#70
Looking forward to it. I'm banking on if the outside temp is around the same, that your 1/4 mile time and trap speed will almost be the same. Using a general rule that 10hp = 100lbs. The 15 horsepower lost would be neutralized by the 150lbs in weight reduction. Keep the 75hp shot (Ktuner to retard timing) and you'd hit a 14.6@99-100mph. Or something like that.
Regardless! I love your progress.
Regardless! I love your progress.
#71
not a FIT, but .......
I havnt had the Fit out yet, but I had my previous commuter out "a few" times.....
Times:
Reaction Time- 0.030
60'- 1.616
1/8 ET- 7.416
1/8 MPH- 93.450
1/4 ET- 118.210
1/4 MPH- 11.689
Car
Year- 2005
Model- GTO
Transmission- T-56/M12 6sp Manual with LS7 Clutch/Flywheel
Mods:
Performance- 502 RWHP / 620 RWTQ
K&N CAI kit, 100hp Nitrous Outlet "Wet Plate" kit (tuned to 10.5:1 afr), Custom ported ls2 intake manifold, Custom ground cam 226/226 591/591 on 112lsa, KOOKS Long Tube Headers 1-7/8" primary with 3" collectors and 3" rantomtech cats, Magniflow "X" pipe, Borla "Cat Back" exhaust
Aero- stock
Wheels/Tires(pressure)- stock wheels, rear tires were Mickey Thompson ET STREET Radials
Weight- 4050#
Other-
Hotchkis Front/Rear Anti-Swaybars, Harrop Rear end cover with polly mounts, BMR Subframe Connectors,
I probably ran this car down the 1320 about 400 times or so, did a couple lapping days at Pacific Raceways road course, and a couple dozen Auto-X events, as well as "spirited" daily driving
commuted 55 miles each way in it for a few years
Pic is me in the same car, different day, different track (Renegade Raceways, Yakima, Wa)
Times:
Reaction Time- 0.030
60'- 1.616
1/8 ET- 7.416
1/8 MPH- 93.450
1/4 ET- 118.210
1/4 MPH- 11.689
Car
Year- 2005
Model- GTO
Transmission- T-56/M12 6sp Manual with LS7 Clutch/Flywheel
Mods:
Performance- 502 RWHP / 620 RWTQ
K&N CAI kit, 100hp Nitrous Outlet "Wet Plate" kit (tuned to 10.5:1 afr), Custom ported ls2 intake manifold, Custom ground cam 226/226 591/591 on 112lsa, KOOKS Long Tube Headers 1-7/8" primary with 3" collectors and 3" rantomtech cats, Magniflow "X" pipe, Borla "Cat Back" exhaust
Aero- stock
Wheels/Tires(pressure)- stock wheels, rear tires were Mickey Thompson ET STREET Radials
Weight- 4050#
Other-
Hotchkis Front/Rear Anti-Swaybars, Harrop Rear end cover with polly mounts, BMR Subframe Connectors,
I probably ran this car down the 1320 about 400 times or so, did a couple lapping days at Pacific Raceways road course, and a couple dozen Auto-X events, as well as "spirited" daily driving
commuted 55 miles each way in it for a few years
Pic is me in the same car, different day, different track (Renegade Raceways, Yakima, Wa)
#73
you could do some street legal BRACKET RACING with those numbers
Ran earlier tonight at Cecil County Raceway. Was testing full J's racing exhaust with Myxal SRI-CAI Ram-Air Intake. Temp was between 66F-70F.
5/22/15 Cecil County Dragway
15.504@90.62mph
15.484@90.86mph
15.445@90.15mph
15.448@91.03mph
15.465@90.27mph
15.448@90.31mph
These have been the most consistent runs I have done in a while. 1/4 mile speed and mph all stayed about the same. I've stretched both the intake and exhaust as far as I can go at the moment. I'm done testing configurations of both. Looking for other power mods now.
5/22/15 Cecil County Dragway
15.504@90.62mph
15.484@90.86mph
15.445@90.15mph
15.448@91.03mph
15.465@90.27mph
15.448@90.31mph
These have been the most consistent runs I have done in a while. 1/4 mile speed and mph all stayed about the same. I've stretched both the intake and exhaust as far as I can go at the moment. I'm done testing configurations of both. Looking for other power mods now.
Thread
Thread Starter
Forum
Replies
Last Post
DOHCtor
Fit Engine Modifications, Motor Swaps, ECU Tuning
74
08-22-2016 08:35 AM
crankshaft
General Fit Talk
17
12-11-2007 09:17 PM