GD3 Clutch Master Cylinder
GD3 Clutch Master Cylinder
This CMC is for a GD3.
Everything was hooked up before finding out that it does not fit the firewall of a GE8 so unfortunately, some small amount of brake/clutch fluid has leached into the CMC. This has never seen actual use from driving. It is basically "new", never used for driving, only used to see if it would be compatible.
All fluid has been drained out. I did not want to remove the piston to wipe down the bore so a very very, VERY small amount might still be left inside.
Parts that will be included are:
GD3 CMC 46920-SAA-P03 (comes with the CMC to firewall gasket)
Clutch Master Cylinder Connector 46941-S5A-A01
Pin Snap (used to hold the connector to the CMC) 46942-S5A-003
These will cost you more than 90 bucks with shipping if bought from an online Honda OEM parts store.
I'm selling all of it for $70 shipped.
Everything was hooked up before finding out that it does not fit the firewall of a GE8 so unfortunately, some small amount of brake/clutch fluid has leached into the CMC. This has never seen actual use from driving. It is basically "new", never used for driving, only used to see if it would be compatible.
All fluid has been drained out. I did not want to remove the piston to wipe down the bore so a very very, VERY small amount might still be left inside.
Parts that will be included are:
GD3 CMC 46920-SAA-P03 (comes with the CMC to firewall gasket)
Clutch Master Cylinder Connector 46941-S5A-A01
Pin Snap (used to hold the connector to the CMC) 46942-S5A-003
These will cost you more than 90 bucks with shipping if bought from an online Honda OEM parts store.
I'm selling all of it for $70 shipped.
Last edited by onemiglandicho; Apr 20, 2013 at 08:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
hyperfit
2nd Generation (GE 08-13)
7
May 25, 2016 05:47 PM
AJR Jay
Fit Engine Modifications, Motor Swaps, ECU Tuning
13
Nov 29, 2012 03:44 PM
