Quote:
Originally Posted by nickroz
Here's my problem. The lower portion of the headunit won't snap in tight. The clips are there, but it's just not pulling it in all the way. It's not getting caught on the cat6 cable and I'm not missing any screws/clips. I'm going to play with the torque on the (2) screws that go up on either side of the A/C controls. Maybe being too tight is causing it to bow.
It's not too apparent in the pictures, but when I try to snap on the bottom A/C coverplate, there's a 1/8 gap on the front.
|
I had the same problem when I was reassembling my head unit. I tried more torque, less torque but I couldn't get the alignment back to perfect on the ac cover at the bottom.
I finally realized that I had used the wrong screws for the radio (the two that are way up high inside and its easier to use a socket wrench to get them). I had used the two screws from the glove compartment. They look very similar, but the length on them is slightly different, so I would double check that because they are interchangeable.
When I switched those screws the alignment problem was taken care of.