|
nobody can help me on this forum?
|
Doctor J, I need your help! Where are you?
|
1 Attachment(s)
I thought ezone will challenge your question:)
You need to make a test light (3.4 watt bulb, NOT Led) with 2 wires soldered to the needle type probes (paper clip wire will work) https://www.fitfreak.net/forums/atta...ine=1470965794 unplug the window switch plug the light probes (from the back side, aka backprobe) into the connector that goes to the switch, #2 and 4 (blue/org & Brn/yell) operate master switch light is out-- check the wires between master switch and door switch light is up but not down (or down but not up) -- master switch must be checked with ignition POWER OFF and master switch in neutral there should be continuity between #2 and #4 cavities of the connector |
Same problem as you kravik. Happened shortly after Honda replaced the switch under the recall. I've tested with a new master switch and it is still the same. Passenger rear will only go down, not back up. Driver side rear won't do either. Motor bench tested ok and fuses ok. Is the picture of broken wire above taken from driverside front door wire cluster ?
Thanks, been very frustrating trying to pin this down :violin: |
With broken wire the window won't go ether way. Do you still have an old switch? If so plug it in and re-check.
You also should go back to the dealer and have them re-check their work (easier said than done!) |
I managed to get the dealer to order in a new master switch as I was pretty sure this was the problem. Unfortunately, the results were the same. I'll have to wait till kids go back to school to rip the driverside door panel off and inspect all the wiring. Still the same - passenger rear will only go down, driver side rear will not go either direction. Front windows working properly.
|
Passenger window can't close bt it can only open down what could be the problem , ,
Originally Posted by doctor J
(Post 1348691)
1) check the 20 amp fuse #15 to the left of steering column (each window has its own fuse), if OK
2) unplug connector from passenger door window motor connect 12 volt 5 watt light bulb (NOT LED) to the harness side in place of motor 3) try the switch if lamp works in both directions the problem most likely the motor. if lamp does not work at all go to step 6 4) if lamp works only in one direction, disconnect the passenger window switch on the connector jump blu/red to red/blu wires ( 2 to 1) and blue/wht to red (4 to 5) using paper clip or equivalent; Operate master switch; if light works on both directions, replace door switch 5) if lamp works in one direction only, replace master switch 6) if lamp does not work at all, connect the lamp (backprobe method) to blue/red and blue/white wires (1 and 3) at the master switch (with switch connected) operate the switch; if lamp works on both directions, troubleshoot wires between switches (using continuity tester); each wire end to end if lamp still is not working at all, replace master switch each window motor has built-in film resistor/breaker which can cause intermittent operation if mechanical restriction or damage to the regulator is present My problem is i have my honda fit new shape , the passenger window its only working when opening it but when close it its not functioning ,down its ok bt up its the problem what colud be the problem |
Probably in the switch. A lot of times you can disassemble them and clean the contacts.
|
| All times are GMT -4. The time now is 01:47 PM. |
© 2024 MH Sub I, LLC dba Internet Brands