Experimental drum brake job (to test a tool)
#1
Experimental drum brake job (to test a tool)
Here is my YT video. Will write instruction later.
BTW one adjuster screw (driver's side) was bone dry from the factory but fully functional
On passenger side there was a very small amount of lubricant.
I only put some Molycote (found on the junkyard) to the shoe to backing plate contact points and to the shoe anchor
BTW a flat aluminum plate with smaller C-clamp to the side of wheel cylinder is for preventing piston from flying out during upper return spring removal
BTW one adjuster screw (driver's side) was bone dry from the factory but fully functional
On passenger side there was a very small amount of lubricant.
I only put some Molycote (found on the junkyard) to the shoe to backing plate contact points and to the shoe anchor
BTW a flat aluminum plate with smaller C-clamp to the side of wheel cylinder is for preventing piston from flying out during upper return spring removal
Last edited by doctor J; 09-22-2018 at 11:28 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Santiad
2nd Generation (GE 08-13)
8
04-20-2019 05:31 PM
2Rismo2
3rd Generation GK Specific Suspension & Brakes Sub-Forum
0
05-09-2016 03:06 PM
FrogDaddy
Fit Suspension & Brake Modifications
17
08-26-2009 02:39 PM