TOPFUEL PowerChamber Type-2 GE8 Intake
#1
TOPFUEL PowerChamber Type-2 GE8 Intake
I got a few questions about TOPFUEL PowerChamber Type-2 GE8 Intake. I'm heading over to the Philippines and a shop I'm in contact with is telling me that they can order it, however they have doubts with fitment with left side driven GE8 Fits due to the placement of the washer fluid tank.
My question is does anyone here fit it into a USDM GE8? Did you have to do any modifications to the brackets and what not? Have you had any problems with CEL and the MAF sensor?
I have seen the installed pics from the GB thread here in Fitfreak. I notice that the setup between those pics and the ones from the Topfuel intake look a little different Is that all I have to do to make it work?
Thanks!
My question is does anyone here fit it into a USDM GE8? Did you have to do any modifications to the brackets and what not? Have you had any problems with CEL and the MAF sensor?
I have seen the installed pics from the GB thread here in Fitfreak. I notice that the setup between those pics and the ones from the Topfuel intake look a little different Is that all I have to do to make it work?
Thanks!
#7
yah priorities priorities.
i can get it from rakuten np, it should take around a week, not a big deal, but I'm really focused on getting the mugen front and grill for the shuttle. maybe i'll get the grill first then the intake, get some use out of the modulo front lip and resell it.
i can get it from rakuten np, it should take around a week, not a big deal, but I'm really focused on getting the mugen front and grill for the shuttle. maybe i'll get the grill first then the intake, get some use out of the modulo front lip and resell it.
Last edited by xxryu139xx; 11-27-2012 at 01:20 AM.
Thread
Thread Starter
Forum
Replies
Last Post
rla217@
For Sale / Want To Buy / Classified Ads for USED Fit Items
1
08-18-2012 11:48 AM
rla217@
2nd Generation GE8 Specific For Sale/WTB Used Parts Sub-Forum
0
08-17-2012 04:42 PM