What's up yall. Sooooo...I went ahead and pulled the trigger on a Mugen front lip and grille. Still waiting for them to come in the mail. For the front lip, I read in the instructions that 3,6, and 10mm drill bits are required.

My stupid question is this: For those of you rockin the Mugen lip, did you actually use metric size drill bits or did you use standard bits that are close to the equivalent?

Thanks in advance!
Jaylom

 

You'll be fine with standard bits as long as you don't drill a bigger hole than you need to.

 

U really don't even need them to be honest, just mark the bumper with a marker though the hole & muscle the screw though the mark.

 

This!!!!!!!!!

 

I appreciate all the help guys. I'll post up pics once I get em installed! I haven't contributed much (been a member since 2008), but I'm constantly on here.