thanx

well, it little bit shorter than USDM one,

 

eh ada apeos.. wakakakakakaka

 

Lookin sooo fly!

 

oit...ada ente disini wakakaaa,,,

 

Hi Amanda...how do you do?
How's your fit mods progress?

 

Thanks Shiro, I think the JDM nose flows SO MUCH better with the rest of the body than the USDM nose.

 

Frontpipe with silencer (resonator)





Centrepipe with silencer (resonator)




(Compare to stock centrepipe)



Next: Dyno Test (curious how many horse power I gained with these full exhaust system upgrades from Header/exhaust manifold, frontpipe, centrepipe and muffler) plus Air Filter Replacement K&N and Intake modification.

 

bump........

 

sesesesSEXY

 

Body reinforcement

Front upper strut bar J's Racing



Front lower underbrace Cusco



Rear under sway bar


Engine
Pivot 3Drive Throttle Controller

 

here's the evolution (will be updated)...

Fresh from the showroom (end of November 2008)


First Mods: Wheels & Suspension (end of Desember 2008)
Specs:
Work Emotion CRKai R17 offset 42 Rims
Tanabe DF210 springs



Second mods: exterior accessories
Specs:
Honda Type R red emblem front and rear
Volk Racing Rays Duralumin Lock Nut blue







Third mods: Engine performance parts
Specs:
Exhaust manifold (header) custom powered by CK Motorsports
Downpipe (frontpipe) custom powered by CK Motorsports
Aftermarket replacement filter by Simota (planning to replace it with K&N)




Sorry no detail pictures on this (forgot to take more )

fourth mod: Wheels
Spec:
Buddyclub P1 Racing R16


Test run on circuit




Vids:

Straight line, Shiro was the second to last....
[flash]http://www.youtube.com/v/9BoezU_oAr8[/flash]
link: YouTube - Honda Jazz GD3 n GE8 at Sentul Straight Line

On board, sorry for the disturbance, my friend hands wasn't a steady one
[flash]http://www.youtube.com/v/i_3OxFRll54[/flash]
link: YouTube - Honda New Jazz RS A/T 2008 with HKS Silent Hi-Power
Muffler at Sentul Circuit

fifth mod: Wheels & exterior accessories
Specs:
Volk Racing Rays CE28 Honda Japan Time Attack Edition R15
Falken Ziex ZE326 205/55/15 tires
Air Scoop custom




Considering to return it to the base wheels


Now....
Local made rims R16 (SSR type F replica)


Next...
USDM tail lights (done) and HKS Silent Hi-Power muffler (done)....




Vrooooooooommmmmmm.......[hr]
SHIRO 2010

carbon bonnet / hood


Ings+1 carbon wing spoiler



Goodridge Brakeline



at sentul 24-01-2010



New Rims BlackRacing Phantom R16 7 inches wide +45 et made in Japan




Kansai Frontpipe with silencer (resonator)


Kansai Centrepipe with silencer (resonator)


Oleh2 dari long weekend di Bandung 26-27 Feb 2010 (Thanx Kang Ronny and Kang Teddy)

Body reinforcement

Front upper strut bar J's Racing



Front lower underbrace Cusco



Rear under sway bar Cusco


Engine
Pivot 3Drive Throttle Controller




Next: Dyno Test (curious how many horse power I gained with these full exhaust system upgrades from Header/exhaust manifold, frontpipe, centrepipe and muffler) plus Air Filter Replacement K&N and Intake modification.

Current specs

Engine:
1.Custom Exhaust System:
a. Custom Header (Exhaust manifold) powered by CK Motorsports
b. Kansai front pipe (With resonator)
c. Kansai centre pipe (With Resonator)
d. Modified Intake Manifold (papas intake) at Lestari Motor
e. HKS Silent Hi Power muffler
2. Pivot Mega Raizin volt stabilizer.
3. 2 pieces Airboom nano air converter
4. K&N replacement air filter
5. Pivot 3Drive Throttle controller - NEW

(not yet dyno tested in shiro, but all of the increasing power was dyno proven)

Suspension
1. Eibach Pro Kit Springs Suspension

Body reinforcement
1. Front upper strut bar J's Racing - NEW
2. Front lower underbrace Cusco - NEW
3. Rear under sway bar Cusco - NEW

Wheels & Tires
1. Toyo Proxes T1R 195/50/16
2. Blackracing Phantom rims, 16", et+45, 7 inches wide (Super Rare !!!)

Brake systems
1. Goodridge braided stainless brakeline
2. Nissei front brake pads

Exterior
1. Carbon bonnet hood
2. Carbon Ings+1 rear wing spoiler
3. Red emblem Honda type R front & rear
4. Rays duralumin lock nut (blue)
5. Air Scoop
6. Yellow painted fog lamp
7. USDM tail lights
8. Shiro decals
9. Perfection Ice Cool clear 40% window tint for front windshield and front driver's & passenger windows, 80% black for rear passenger's windows and rear windshields

Interior
1. Honda Red emblem steering
2. Custom floor mat by CK Motorsports
3. Full LED interior lights
4. Super spring SF410 5 inch GPS

 

Forgot 1 exterior mod...the window visors.

 

and interior, red emblem steering... lol

 

Wow, good looking car!

 

thanx man.....

anyway...update....











coaching clinic by one of national racer

 

I like those rims...the newest ones. They look like LS Meshies a lil bit.

Me likey! Wish I could get half of what you have...

 

Thanx a lot Amanda...

Is there a lot of aftermarket parts for GE8?


my fave picture....

 

mmmmm i want the JDM Sport Bumper so bad. Wish there was a way to make it work on US front

 

New Shoes again.....
Enkei RPF1 type II 16" et+45 7jj gunmetal made in japan



yellow painted oem taillights turning signal

 

Lattest addition on Shiro.

1. Spoon N1 Muffler


2. Rear Diffuser Spoon


3. Piggyback Unichip Dastek type Q+
running on dyno


4. ATE Power Disc Rotor


5. Project Mu Floating Lug Nut



6. HID 4300k Head lamp and 3000k fog lamp


7. Tein Super Compact Coil Over





Shiro Spoon