Looks amazing!

 

very clean and simple i plan on getting the same diffuser too but for now i just painted my diffuser

those lights do look nice...maybe i'll be getting those.

 

Nice clean looking car, I like the taillights. Did you do anything inside?

 

Gorgeous setup.

 

Hope to get a few more shots in before the cherry blossoms go away this year.

 

clean I like the way you painted the lip. One of the cleanest fit here in the forum no doubt!

 

Fit looks sick with the mugen front and stock side skirts and rear. I'm still debating if I wanna paint match my lip or just sell it. Lol

 

The fit now has 17" beater forged wheels on. Much lighter, much more pleasurable to drive.

Will try to put a photoshoot togethe in a couple weeks when I have time to wash the car and hope the weather will cooperate

 

Again, so beautiful. What kind of finger-gap do you have front/rear? I'm trying to perfect my coilover stance this week.

 

its about 1.5 gap in the front, and 2 in the back i can't go any lower as for some reason, the right front coilover is already adjusted all the way down, but the front left has a few more threads to go. its too bad cux i want it a tad lower in the front.

 

You're on Tein's right? I'm low as you can see, and am nowhere near maxed out...strange. However, your ride height is just about perfect so no need to worry

 

i am about at the same height as u are. what are you lowered on?

 

Tein Street Basis, and I'm running about a 1/1.5 finger gap all the way around.

 

yea then we are running the same coilovers. I don't know why my height adjustment is so weird.

 

Do you still have thread to go any lower ?
I am rolling on the super compacts and it should be the same setup other than the valving difference and spring rate but I was able to tuck in my rears just for fun when I first put in my suspension.

 

Make sure you measure it on a flat surface. Because the rear is a solid axle, the slightest dip or raise on the ground can raise the wheel gap up to an inch.

 

Yep it still looks like I have at least 1/3 of my thread all the way around. Good point about solid ground inkster...now if I could just find a surface w/o a giant hole in Bmore.

 

I am all the way down on my right front side, maybe one more turn.

I have about 5 more complete turns on the front left.

The rear, i have a lot more to go.

it's about 1.5 finger gaps on the front and about the same on the back.

 

Something isn't right....

 

First photos of my beater forged wheels, the weather is cooperating and the car is clean. It is time for a better location shoot.