Fog Light Bulb Replacement
I got LED replacement bulbs for the fog lights. Is it true that the whole assembly must be removed - the outer cover and then the light itself and finally the bulb? I haven't looked behind it yet, but that would be the easy (non-Honda) way of doing things.
EDIT: I just tried to remove that black cover surrounding the light - no luck. There are three tabs on each side, but using plastic trim tools had no effect on them. EDIT AGAIN: Got it! https://www.carcarekiosk.com/video/2...lights/foglamp I even have the black gloves! : ) |
You access the fogs from just underneath. It's the plastic panel in front of the wheels facing the ground.
|
Originally Posted by Action Jackson
(Post 1398209)
You access the fogs from just underneath. It's the plastic panel in front of the wheels facing the ground.
I didn't even jack up the car. Just parked near the step down from the garage and that was enough clearance to easily access it. |
Originally Posted by 2Rismo2
(Post 1398210)
Yup, there is a little panel that you push in. If I remember there is a screw or something keeping it close.
I didn't even jack up the car. Just parked near the step down from the garage and that was enough clearance to easily access it. |
I looked and am not seeing this panel you refer to. I wish I could see a photo of it - I searched the usual sources but did not run across one. I will put it on ramps this weekend to get a better look - I'm sure I'm just missing it in plain sight and I will smack myself when I figure it out.
Thanks! |
I didn't see a panel, either. I followed the video, but removing that one screw does not give you much room. You have to disconnect more of that fender liner. You have to push in on a tab to release the bulb from the socket.
https://www.carcarekiosk.com/video/2...lights/foglamp |
The panel is directly facing the ground under the wheel liner in the video. It is a little harder to reach the bulb compared to the video.
|
I find it works better to remove the bulb before trying to disconnect the harness, contrary to the instructions in the manual. |
All times are GMT -4. The time now is 10:28 PM. |
© 2024 MH Sub I, LLC dba Internet Brands