[/HTML]Picked up the car and got it tinted 1st week
35% front 25% rear by Rich's Tint Shoppe

 

picked up burnt ti exhaust finisher tip. my sheltie kiki approves

 

25mm spacers installed on the rear to even up the wheel gap

 

plasti dipped lower portion of the rear bumper.

 

Car lowered on tein s tech springs.

 

Hate to admit it, but nothing looks better than a WOP GK that's been tastefully LOWERED!!!!! Unlike mine, your add-ons are just right.

Went over-board buying all the little accessories and me thinks my little Fit is now too "busy". That goes double for the wife who comments it fits our island lifestyle - bright (specifically the artsy wheels) and somewhat colorful!!!!

Glad you joined the GK pic forum. Keep posting. BTW, like that chrome exhaust tip!!!!

 

Car looks awesome! Love the dipped rear bumper and the exhaust tip. What size exhaust is it?

 

Its exhaust tip I found on eBay. I know many shopping sites has similar ones. Its a bent clamp on exhaust tip.

 

Red Type R style emblem received today from ebay seller
awesome quality badges.
i didn't take any picture of the installation but they were simple. I pryed off the honda emblem cuz i knew i wouldn't reuse them.
Front badge was perfect fit without having to do any trimming of clipping of the prongs.
Rear badge needs some sanding. It was 1-2mm too big and needs some sanding to get the badge to fit.

results

 

You car looks great.

That front tint though can get you a fix it ticket in California depending on how aggressive the police are where you live.

 

Who was the ebay seller for the badges and if I can ask what was the cost??

 

https://www.fitfreak.net/forums/3rd-...h-emblems.html

 

experimented with some decal designs
this is my mugen inspired stripes

 

I like the stripe. Don't get too crazy now!!!

Hey, where did you get that Vtec sticker? I wasn't going to put them on my car but those are pretty low profile with the "blind" effect.

 

Could you help out with sourcing the exhaust tip?
Also you only did rear spacers? How flush is compared to the front.
25mm 4x100 56.1 hub bore?

 

Didn't like the new look of the fits but it is growing on me. Yours looks good. I haven't seen to many around my area besides at the dealerships.

 

Anyone else having trouble viewing these images? I can only see 5 out of the 17. Kenji, were the badges hard to install? I have never done them before and I am considering ordering front and rear ones from ICB Motorsports. Thanks.

 

Looking good. I like the subtle mods. Very clean. Keep it up, and keep us posted!

 

fixed the broken links.
the badge is not hard to install just pry off old badge it's held on my two pins. I did not want to keep original badge so i just broke them off.
got bored and added some new side decal

 

a little sneak peak of what's coming