Honda fit gd1 2005 rear bumper make a hole for dual tip muffler exhaust
Thread Starter
|
Member
Joined: Feb 2015
Posts: 22
From: ARGENTINA
Honda fit gd1 2005 rear bumper make a hole for dual tip muffler exhaust
Hello guys i have and Honda fit 2005 and i m going to put new springs that lowered the car about 8/10 cm left.
The problem is that I wanted to put a muffler with dual tip and if the car is too low i have to try to put very high the rear muffler to avoid the touch the muffler with the Street.
Here is my car all stock and what I wanted to do.
I have bought a rear bumper protect muffler heat is a piece about 13 cm long i have to paint in White or black
i dont decide yet.
my car
how i wanted to look but with the muffler much high
the heat shield
The problem is that I wanted to put a muffler with dual tip and if the car is too low i have to try to put very high the rear muffler to avoid the touch the muffler with the Street.
Here is my car all stock and what I wanted to do.
I have bought a rear bumper protect muffler heat is a piece about 13 cm long i have to paint in White or black
i dont decide yet.
my car
how i wanted to look but with the muffler much high
the heat shield
Last edited by MISTERHONDA; Feb 9, 2016 at 01:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post
exarchangel
Fit Engine Modifications, Motor Swaps, ECU Tuning
14
Sep 1, 2014 04:58 PM
pwnstar
Fit Engine Modifications, Motor Swaps, ECU Tuning
3
Nov 13, 2008 11:08 PM