hi, was wondering if anyone out there would like to share their personal experience with installing the spoon n1 axle back (back box)..

how hard, how long, tools needed, etc

thanks

 

its super easy.couple of bolts and hangers.shouldnt take you more than 20 minutes to do

 

12mm socket, ratchet and some WD-40. Remove the two bolts with spring to seperate muffler from b-pipe, then with aid of WD-40 push out the two hangers behind the back of the rear bumper. Spray WD-40 into rubber hanger and install new exhaust, should be fairly easy with lube inside to get the hangers in.

 

thanks guys, that sounds easy enuf.. hopefully if the weather is good 2moro i will give it a shot...

 

i say tackle that is right now lol

 

does the jdm spoon n1 exhaust fit the usdm fit? i heard it would be 2.5" shorter than the jdm fit.

 

I think they are all JDM exhausts. Mine is tucked in pretty far but it looks good, not sticking out all obnoxious.

 

finally got a chance today to fit it, looking well, sticks out bout half an inch from the bumper..

quite loud in my opinion, didnt take that long to fit for a novice like me who have never fitted an exhaust before.. simple enuf..

but had a minor problem wen screwing the spring bolts bak on, i broke one of them by over tightening so have to go to honda 2moro to pick up a new one.. not exactly sure how tight they shud b an ended up breakin it...