Heloo guys, this is my setup and my style on how to install and tune a GD3 Vtec with Turbo...
this one is using HKS Turbo full Kit with Oil Cooler Kit

So basically my jumper are
JP1 - 6 = OPEN
JP7 - 8 = 1-2
JP9 = OPEN
JP10 = 2-3
JP11 - 12 = OPEN
JP13 - 17 = 1-2
JP18 = OPEN
JP19 - 20 = 1-2

And here I also try to describe my pinout schematics

A2 = +B
A5 = #E
A6 = O2
A7 = Ne
A9 = Kn
A15 = Th
A18 = SPD*(MT)
A19 = Ar
A24 = E
A26 = G2
A27 = IG4
A28 = IG3
A29 = IG2
A30 = IG1

B2 = #4
B3 = #3
B4 = #2
B5 = #1
B8 = W
B15 = VTEC
B17 = A

I connect the crank and cam so i dont use the rpm signal
also i am connecting the water and air temp to my emu
I am using Latest Profec BC and Greddy map sensor
Running great on dyno and producing only 130whp on 5th gear pull and 0.34 Bar boost
Now running on 0.71 Bar with stock internal
My ca is AT so very hard to push the ECU into Open Loop mode
been fighting it till now
but finally made it to open loop it and producing 12.0-11.1 AFR on FUll Boost

I did tried and take times during tuning this car for a whole month with some different setups and jumpers also connections

I also have lots maps and data logs if any of u feel need reference
just pm or email me thanks