Long time no post.... Yea Yea Yea, I know I have been MIA but the guy that purchased my old GD3 needs a few questions answered. He will post in this thread I'm sure but he decided to go with an HID kit that that on this site may not 100% prefer. He didn't do the JDM HID Retro fit, but went with a cheaper HID kit that was more in his budget at the time. Unfortunately he cut the rubber boot a tad to much on the passenger side and he is have water vapor issues. Now I remember back in the day with the EG, EK, & DC chassis you could just remove the glass from the headlight housings in the heated oven. Though I have not done this on a newer model Honda chassis.

Is this the same method on this GD3 headlight housing? If so are there any type of gaskets or rubber o-rings that will be needed to replaced in this headlight housing at all?

Well all comments are welcome as always and if he posts in this thread dont flame on him... lol...

 

use a heat gun, its easier to take it off

 

Anyone have any suggestions on sealing up the back around the bulbs, as the stock rubber does not work w/o modification, and then is very easy to tear afterwards.