My BBP 08 Fit Sport
Thread Starter
|
Member
Joined: Nov 2008
Posts: 249
From: Beaumont, TX
My rears are modded on the ProC's. My only hate about the coils was the limited rear adjustment.
Remove the collars as said. My bases are sitting in the bottom spring mount. Theyre suppose to sit upward (against body) but I didnt like them sitting that way. Plus, the spring rubbed and caused noises.
If your bases arent sitting in the lower spring mounts reverse it, then pull the collars.
Itll bring the rears down another .5in to 1in.
Remember once you do this theres no adjustment. Youll have to put the collars back in for any kind of height adjustment.
I personally think it sits nice.
Remove the collars as said. My bases are sitting in the bottom spring mount. Theyre suppose to sit upward (against body) but I didnt like them sitting that way. Plus, the spring rubbed and caused noises.
If your bases arent sitting in the lower spring mounts reverse it, then pull the collars.
Itll bring the rears down another .5in to 1in.
Remember once you do this theres no adjustment. Youll have to put the collars back in for any kind of height adjustment.
I personally think it sits nice.
tryin to make more sense of what you said, so you are basically running straight spring in the back with the rubber under the spring?
Thread Starter
|
Member
Joined: Nov 2008
Posts: 249
From: Beaumont, TX
lol almost a close match. my mugen visors are in today
imho, i think 16's look better, 17's just look too massive. my car originally
came on 17s from the dealer (show room car) but i had to get rid of em.
Thread Starter
|
Member
Joined: Nov 2008
Posts: 249
From: Beaumont, TX
a few more "low quality" pics taken by a friend yesterday. pics were taken with a camcorder and car is filthy. hard to keep anything clean here in southeast texas, weather goes from hot-cold-rainy-foggy-windy etc. all within 1 week, its ridiculous
Enjoy :
Enjoy :
The bases are there, but no collars. The collars are what the springs sit on to raise and lower the car.
Seeing those pics above it sits fine for the modded rears.
Are those Motegi's on a TL? :-/
Thread Starter
|
Member
Joined: Nov 2008
Posts: 249
From: Beaumont, TX
agreed. he knows they arent the best wheels but they were a gift. he's working on some vsxx's at the moment.
i took the collars out only for the rears. it sits fine for me i just wanted to eliminate the wheel gap
i took the collars out only for the rears. it sits fine for me i just wanted to eliminate the wheel gap
Thread Starter
|
Member
Joined: Nov 2008
Posts: 249
From: Beaumont, TX
yes in these pics the collars are removed. it lowered it about 1/2 an inch. just low enough to eliminate the tire gap
Thread
Thread Starter
Forum
Replies
Last Post
