Which side did you cut the coil off of? Where the coils are closer together or further apart? Thanks for the help!

 

Skunk word faces upright not upside down. Cut bottom. One full coil is dead level. Hope that makes sense

 

Yep, that makes sense. Thanks man! I've got the S-Techs and think they sit too high in the back, would rather be level. +rep for you!

 

Duckbilled her ass

 

Tsudo Cat Back Exhaust is on along with Aspec test pipe wrapped.





Here is the exhaust clip. Camera was close to it on start up so has a different noise. This thing is loud and im gonna reinstall factory cat to test it that way next. I do love it though....

YouTube - ‪2008 Honda Fit‬‏

 

Clean undercarriage! As always look'n better all the time!
Big Mike

 

Undercoated rear wheelwells. Got rid of that ugly well look for something more clean.






Here are a couple shots from a local show last weekend with some peoples...







Took test pipe off, and reinstalled factory cat. Sounds alot better now. Not as loud, i can actually drive it now.

YouTube - ‪2008 Honda Fit Exhaust‬‏

 

looks really good! how do you like tsudo exhaust? i was so close to picking one up when i came up on a deal for a spoon catback that i couldn't pass up :P

 

Tsudo Cat back is great. Truely a quality piece. Sound is gorgeous deep sound, not ricey fart can at all. Price? well thats the best part................

 

They keep standing them up and you keep nock'n 'um down......
Look'n betta every time that I see it B......

 

Couple new shots for ya.

JDM Hazard Switch installed



And a couple solo shots

 

Like'n the new exhaust B so whats the hp gain feel like?

 

^^HP gain is subtle Mike. I can feel it, but its not pin you to your seat type. Feels strong in mid to upper rpms. Sounds really good though.

 

Ya 20% gain is 2.1hp if it did pin ya in the seat that would be my next mod

 

More solo shots











Thats call this a DUET:

 

More shots coming:






And another Duet with Matt:

 

wow i love your MR FIT. do u have the template for the side markers and the duckbill? i will be investing in one soon.

 

^^ go to the exterior section and download the side marker template. There is a diy thread on there. I just used specs and made my own template. Tape it off, lay index card template on, draw it out and cut with dremel. As for the duckbill I taped off and measured a million times. Then drilled two holes to fit. I used three m tape to cover stock holes. Worked great. Ryan roland did a diy on that as well.

 

Nice i love the Fit couple of questions one is how did you like the skunk springs. I have had mine for about 6 months now and have not installed them i'm scared i will rub and hate them. Also how did you paint the runners in the engine gold? Did you just tape every thing else off?

 

^^ The skunk springs were great. On stock wheels you will not rub at all. They ride good and handle good as well. Put them on you will love them. I switched to tein springs to go lower then skunks.

Now for the intake. I removed the whole thing to install a password jdm gasket. While it was apart I painted the intake high heat gold. Turned out very nice. Matches perfect with my password jdm fender washers.