So yeah...installed my Tanabe goodies
#1
So yeah...installed my Tanabe goodies
Long story short. Pics MAY be up but noticed a smudge on the lens. Installed the following items:
Tanabe Front strut bar
Tanabe Rear strut Bar
Tanabe GF 210's
Tababe Lower arm bar
Everything went well except the passenger side axle decided to pop out just when I got the top strut bolt out. :| Needless to say, it wouldn't wiggle back in so I had to take the boot clamps off and repack the bearings and put new clamps on. I hope that they hold. I may take it to Honda to have them redo it just so they are real Honda clamps. Pissed me off and lowered my motivation to post pics this minute. If they turn out, I will post them later.
Other than that, everything was ok. Axle grease is everywhere though So oh well.
Kris
Tanabe Front strut bar
Tanabe Rear strut Bar
Tanabe GF 210's
Tababe Lower arm bar
Everything went well except the passenger side axle decided to pop out just when I got the top strut bolt out. :| Needless to say, it wouldn't wiggle back in so I had to take the boot clamps off and repack the bearings and put new clamps on. I hope that they hold. I may take it to Honda to have them redo it just so they are real Honda clamps. Pissed me off and lowered my motivation to post pics this minute. If they turn out, I will post them later.
Other than that, everything was ok. Axle grease is everywhere though So oh well.
Kris
Last edited by fit4kris; 04-13-2007 at 06:05 PM.
#2
#6
Hi Kris-
Good job on the photos. My curiosity with your new parts concerned the difference between the Tanabe front strut bar and the one from A Spec. The two seem to have similar tower brackets, but the Tanabe looks like it has MUCH better fasteners. It also looks like the bar eye bolts are TWO pieces- the eye bolt, with a separate jam nut that locks it against the end of the bar. Without being able to see it in person, it appears that the Tanabe kit is worth the extra $20-25.00 over the price of the A Spec front bar. Thanks for taking the time to post your photos.
Dave
Good job on the photos. My curiosity with your new parts concerned the difference between the Tanabe front strut bar and the one from A Spec. The two seem to have similar tower brackets, but the Tanabe looks like it has MUCH better fasteners. It also looks like the bar eye bolts are TWO pieces- the eye bolt, with a separate jam nut that locks it against the end of the bar. Without being able to see it in person, it appears that the Tanabe kit is worth the extra $20-25.00 over the price of the A Spec front bar. Thanks for taking the time to post your photos.
Dave
#7
wow man that sucks about the axle popping out. My driver side axle popped out but me and my little brother spent about an hr trying 2 get it back in and after countless rotations of the axle and curse words, he finally got it to pop back in. We made sure the same mistake didn't happen on the other side.
Thread
Thread Starter
Forum
Replies
Last Post
Jz1219
For Sale / Want To Buy / Classified Ads for USED Fit Items
9
09-10-2012 11:29 PM