2008 Factory Alignment Specs? Help!
Thread Starter
|
Member
Joined: Jan 2008
Posts: 449
From: Allen (Dallas), TX
2008 Factory Alignment Specs? Help!
Did searching but didn't find a clean cut answer in one place showing the factory alignment specs. None of the local shops have 2007/08 info yet, and hate to go to the dealer.
Thanks!
Thanks!
Member
Joined: Jul 2007
Posts: 1,584
From: Memphis, TN
The front camber will be about 0*, +/- 0.5*
The rear is probably gonna be about -1* +/- 0.5*
That's assuming you're on stock suspension, though.
The rear is probably gonna be about -1* +/- 0.5*
That's assuming you're on stock suspension, though.
Last edited by cojaro; Nov 24, 2008 at 01:44 PM. Reason: Forgot to mention which suspension angle DOH
You need a camber kit front and rear or they'll only adjust your toe. I had the same issue. I'm riding on vogtland springs, stock shocks for 2 weeks now ;/ they'll be fine for a month or two I'm guessing.
really? negative numbers are toe-out condition. just looking
at the rear there's plenty toe-in.
Member
Joined: Jul 2007
Posts: 1,584
From: Memphis, TN
I'm retarded. That's camber. I haven't a clue what the stock toe alignments may be.
doh, i was thinking toe for some reason but yah, if it is camber
im sure that's about right.
somewhere in my FitBlog i have the factory spec vs my car's measurements.
(in the newb section).
im sure that's about right.
somewhere in my FitBlog i have the factory spec vs my car's measurements.
(in the newb section).
Thread
Thread Starter
Forum
Replies
Last Post
