Hey guys, DME - Design Motorsports Engineering is finally up!!

Theyr'e got some good stuff on it. Just curious if anyone has used any of it.

 

my brother is a tester for DME products for the scion tc. so far, we have found they're products to be subpar to other known brands. We tested:

-Front strut bar= bends a flexes easily, does not provide same stiffness compared to the Hotchkis one-piece strut bar. DME's bar is a 3-piece, which is not usually preferred.

-Rear strut bar= could not even install the thing without leaving the trunk carpet off. Again, its a 3-piece and very flexible.

-Radiator plate=fitted perfectly, but no real performance factor. mainly just for the bling factor.

-Engine damper=pending, still waiting for it to arrive.

overall, dont be too quick to jump on their stuff.

 

wow, that's more info than i expected to get. Thanks so much!!! I guess, i'll just stick to teh guys at AJR since they're the best vendor out there.

 

AJR has done a great deal to Honda's for a long time.

but keep an eye on DME, they have a knowledgeable fabricator behind them somewhere. My bro was testing pre-released products, so they probably improved the product since then. but he'll tell me if they did change the design.

 

well...i spoke to one of the guys at DME here in socal so he's gonna hook me up on their headers. Once i get em in, ima make a FULL review + install + butt dyno and prolly some vids. Keep an eye on them they got some dope stuff.

 

Tagged for interest.