Exactly like it says, what would you like to see DIY-ed???

 

t1r turbo kit.
coilovers.
sun roof.
carbon fiber hatch.
spoon 6 point roll cage.
balanced and blue printed internals.

simple stuff like that.

 

A step-by-step on installing the Acura CL maplight with Homelink onto the Fit!

 

Map light DIY would be nice since Im afraid to cut my headliner.

 

J's racing 3D GT wing on a Sport.

 

the j's wing is a simple drill some new mounting holes and bolt it on. the real problem if figuring out how to fill up all the oem holes. for fun take off the sport spoiler to see what im talking about. i think there are at least 5 oem holes.

 

Ugh. Lame.

 

just get the spoon duckbill cause it covers all the oem holes. i used some silicon to plug up the holes since it tends to rain in washington and i dont want the inside of my fit soaking wet.

 

could you write up a diy on how to get three chicks at once? with pictures plz.

 

I second this.

 

Installing f90bt (although I plan to DIY it myself once I get money for all the parts, assuming I can figure it out) or the Gentex HomeLink mirror on an '09.

And +1 to moonroof.

Good question. Any chance you're going to get around to any of these?

 

 

Some sort of added offroad/driving light set up either in the front bumper (I saw some pics of a blue fit a while back) or a light bar on the roof.

 

that light bar was photo shopped onto that fit. there are some fits in the philipines that have a rally car setup with the 4 lights on the front bumper.

 

need homelink now!!

 

JDM conversion?

 

hahh i second that

 

I want to see a real, step by step, in detail, "how-to" on the K20A2 swap into the GD3.

I'm talking turn-key.

 

Make lots of money, Buy the parts, take it to a shop, pay lots money, and there you go turnkey k20 GD3

 

building a sub box that replaces one or both of the rear side panels without losing too much rear space but keeping it looking stock. say around a 8" sub.