Fit suspension design?
Thread Starter
|
Member
Joined: Oct 2005
Posts: 161
From: Corporation, CA
Fit suspension design?
Is it true the fit uses a torsion beam in the rear? Wouldn't this be inferior to wishbones? I know honda was thinking flat floor design but who would choose a flat floors over suspesion performance?
Last edited by Halo; Nov 2, 2005 at 07:02 PM.
Thread Starter
|
Member
Joined: Oct 2005
Posts: 161
From: Corporation, CA
https://www.fitfreak.net/forums/show...ght=suspension
I searched and found this..my main question is where does Honda place the tie rod ends..are they attached to the actual shock like the DC5 and EP3?
I searched and found this..my main question is where does Honda place the tie rod ends..are they attached to the actual shock like the DC5 and EP3?
Thread
Thread Starter
Forum
Replies
Last Post
blackndecker
2nd Generation GE8 Specific Suspension & Brakes Sub-Forum
38
Oct 28, 2011 09:08 AM
