Selling off my 4 channel amp!

It's missing one set screw, if you really want i can go and pick one up at the local screw specialist shop before i hand if over. The pics are a bit exaggerated... I guess that's the bad thing about taking pictures with flash. But the unit works flawlessly, SOLID AMP.

http://farm5.static.flickr.com/4064/...bed869f0_b.jpg
http://farm5.static.flickr.com/4008/...099f640a_b.jpg

Thanks.

Rated Power (stereo):
45W RMS x 4 @ 4 ohm (12.5V);
75W RMS x 4 @ 2 ohm (12.5V)
Rated Power (bridged):
90W RMS x 2 @ 8 ohm (12.5V);
150W RMS x 2 @ 4 ohm (12.5V)
THD at Rated Power:
<0.08% @ 4 ohm (20 Hz - 20 kHz)
S/N Ratio:
>104 dB referred to rated power (A-weighted, 20 Hz ���� 20 kHz noise bandwidth)
Frequency Response:
10 Hz ���� 25 kHz (+0, -1dB)
Damping Factor:
>200 @ 4 ohm per ch. / 50 Hz,
>100 @ 2 ohm per ch. / 50 Hz
Slew Rate:
ￂﾱ 22V/ￂﾵs
Input Range:
200mV ���� 8V RMS
Dimensions:
13.8" x 9.25" x 2.36"

Features:
Absolute Symmetry���ﾢ Class AB Circuit (U.S. Patent #6,294,959)
Differential, Noise-Cancelling Input Topology:
RCA jack inputs (low-level) and multi-pin jack (high-level)
On-board Crossover:
State-variable, 12dB/octave Butterworth with continuously variable cutoff frequency selection from 50 ���� 200 Hz. Configurable as Low-Pass or High-Pass

Preamp Output:
Pass-through type.
Speaker output connections:
accept up to 8 AWG wire
+12V and Ground connections:
accept up to 4 AWG wire

e4300 - JL Audio 4 Ch 300 Watt Amplifier

Lightly scratched,

asking for 200. thanks