Speaker, fender signal lights, inner fenders, and rear seats today,


she also had dry upper spring rubber, so a good silicone soak and she's nice and quiet now.

 

 

 

Dyed the cargo cover, it turned out great
used ritz charcoal grey dye, a heavy duty spray bottle and a soft brush to blend the color.
Worked.out good...

 

It's official she's ready to sell!

 

 

Changed the trans fluid, there was a/t/f in a 5 spd. man.? Cleaned the case and painted the plugs, look'n good my man! Wet sanded the blesishes out of the hood and buffed. Bought a timing light with 60 degree advance, I remember when that was a biggie, $26.00 at harbor freight. Ran out of Getty up so I'll check the timing tomorrow.

 

Clutch safety switch stop
Pulled the clutch pedal out to replace this bump stop. Honda you could have used rubber instead of the urathane. I was reading where one fellow used a piece of garden hose to slide down over the hole and will probably out live him :-D
i had it fall apart in the food lion parking lot yesterday after work. And it was about a gizillion degrees out. I figured I could push the switch in and turn the key so I could get home.haha I bet that was a funny sight me upside down hanging out into the parking lot.

The good thing is that it's good for another 25 years.

 

 

 

Ben's mom owns this beauty. Replaced exhast/ intake gasket, drilled out ss stud that was broken off in the head, O2 sensor and wiring harness plug, t-stat, and cap. But i had to do a little detailing :-D

 

 

 

 

 

 

We painted the top today not purfikt but nice.

 

Brake pads and rotors

 

She stops on a dime and leave ya change now

 

1931 chebby pu hood driver's side. Before

Fender: before

Fender: after

Driver's side done, next weekend want to finish, if weather allows.