I don't have pics to explain, but this should help everyone out:
Use a flathead and pry the two things off their hooks (the pull handle you use to close the rear hatch) and pull out the pull handle.
Using same flathead, push the little circles on the 2 clips next to the pull handle and pull them out.
Start pulling down and around to undo the inside panel clips.
Take off the wiperblade and the little piece to expose the 10mm nut.
Unclip the wiper motor harness, unbolt the 3 bolts keeping the motor secured.
Unbolt the 10mm nut on the outside to let the motor fall out (have one hand inside holding the motor and one hand unbolting the nut on the outside).
Remove the rubber wiper grommet thing outside.
Unbolt the main bolt keeping the existing garnish attached inside
Push the 2 black clips and 3 white clips up and out to push the garnish off.
Now take ikona's garnish, take off the washers/nuts he provides, slide all the screws into the holes. Make sure the rubber underneath the rear glass goes over or flush with the garnish. Don't let it get pinched. Use a flathead carefully to pull the rubber out if that happens.
Put the washers/nuts on tightly, I think they were 8 or 9mm. Put the red rubber protectors back on now.
Then put the big inside panel back on (press so all the clips pop back in).
Then reinstall the pull handle by just sliding it in til it clicks.
Boom, all done! Sorry I don't have pics to explain. I'll take pics of the shop manual instructions when I get around to it. Hope that helps!
