DIY Spoon Spoiler please.?

[fitfit123]

could anyone write a write-up on how to install the spoon spoiler?? thx

[JDMchris.com]

I shouldve when I installed my friends.

Anyways, with the Spoon spoiler you receive a Template that go on either ends and one in the middle. (I cut out the middle bolt so i didnt have to drill 3 holes.)

Once the Templates are in place test fit the spoiler, make sure the bolts will line up on the template.

Next you can use a punch to keep the bit in place, or just start drilling.

I would recommend gettting some touchup paint and paint the raw metal after drilling to avoid rust.

Would also recommend some doublesided tape for the middle of the spoiler altho its not required.

Open up the hatch and place the nut/washer on the bolt and tighten and your done.

[Raimondas]

Chris has it covered. Measure many times, drill once. I used all three bolts for mine, I hate tape. Also painted the nuts/washer body color. Good luck.

[saiko]

Good thing I looked for this, didn't know you had to drill to install.

[FELIXY69]

so u have to drill a big hold on the inside of the hatch so you can tighten the nut from the spoiler ?

any pics to explaine this
i got a fab spoiler and seems like the install would be the same ?