Got a few options again. I'm thinking of the following will have to see when i get the frams.

1. either attach the tilt bar to the number plate but drilling the reg plate.
2. drill the tilt bar and number plate, to align with the holes on the plate frame.
3. drill the frame to align with the tilt bar.

I'm thinking number 2 cuz i don't wanna drill the frame cuz that's more moneys or just drill the number plate to float it higher a little and avoid drilling the frame.

 

Lucky you, you have so many options in car wise lol
Get pics up when you have it done

 

Spraying the rims and wheel nuts tomorrow.
Then lowering it later this week.
Hopefully the fog bulbs aud number plate frame will have come too.

 

Thought I'd share some more photo's of my whip. After the Casino my car looked like it was lurkin so the camera came into action













Enjoy and thanks for looking :L

 

typical chinese at the casino man. lol
Looking good. I put an order in for them led tails today. hope to see them arriving soon. i'll let you know bro.

 

Looking good dude! I'd like to see it with some proper jap sized plates instead of bike one's though.

 

Yeah Tommy re-plate with the illest frame and tilt bar mate!

 

Haha got too take a late night trip to casino after work :P let me know on the leds

What size are the proper jap playes? I will get them sorted tommorow

 

not sure myself.
but i would get the frames first imo. just in case you get the wrong ones to fit the frame.
at least you can take the frame to the designers and say you want your plate to fit the frame.

 

Illest License Plate Frame - Fatlace stance fresh clean haters gonna hate | eBay

Aww mate this is the one! Do it! 12" x 6" should be JDM size

 

Im ordering them right now from Demonplates. 330mm x 165mm,

 

I mean 330mm x 152mm

 

Yup 12" x 6" is jap sized.
Should look a whole lot better

 

Yeah should look so much better, iv been waiting to get new plates, ordered from demonplates... They on the way. 330mm x 165mm which is 13" x 6.5" i think. They only do 13" wide for import plates... But for height they do 152mm, 165mm, 178, and 203mm.
I went for 165mm height because 152 would look too small on the rear...

 

always better to get frames first then the number plated made.
Or at least order larger and then try trimming them down to size for fitment.

Good luck and upload pictures!

 

Not feeling the frames, keeping it clean playes should areive tommorrow in post

 

Next to the monster






Jdmlifestlye <3

 

Nice one dude.. looking spot on.
We should do some shots together. let me get my car going first and i'll upload some pictures.
Maybe make my thread up after i come back from my holiday.

 

looking good man, like the jdm lifestyle! new deflectors? and what is that sticker on the door? good to see you got the right size plates now too!

 

oh yeah.. just noticed you got the deflectors on now.. what do you think of them?
ok? Not ok? Quality? imo.. not gr8. but will do for now.