I just finished a cyl head gasket replacement on my 2008 Fit, and I had this part left over. Anybody know what it does and where it goes in relationship to the head? I looked for pictures in the manuals and could'n t find it.

 

ouch..

i would ask GAFIT or Hootie for their insight on GD's.

 

I will look under the hood later, but that looks to be the bracket that holds the fuel injector harness on the backside of the motor maybe?

 

It's obviously a bracket to hold a cable or line in the proper location. Shouldn't be too hard to figure out. The square hole is for locating the part and the hole next to it is for the fastener. You should have one bolt also left over or the bolt is treaded into where the bracket goes. Just look at where the cables or lines are and look for the square tab to locate the bracket.

 

would you have a service manual by any chance, GAFIT?

 

I have a service manual, but looking for a single part is kind of tedious.

Adding to what Rob said above, take a look behind the dipstick. I see a bracket similar to that behind the dipstick that is holding a wire loom.