I can't find any decent ones for the GE8! Are the GD3 camber bolts compatible?

 

what undecent kits did u find?

 

you need to order part # 90188-SCC-A00 Qty 2

from norihito1@gmail.com

That's what I am using on my car.

 

Its mostly ebay ones and overpriced for just bolts!

 

Thanks for the part #, I just found it here. But I will try to see if my local dealer have it instock.
90188-SCC-A00 - Genuine Honda Bolt, Flange (14x57.3)

 

I have two for sale, see my sig...

what is the above picture for? That is not where the camber bolt goes, that is the mount for the sway bar endlink.

 

State side dealers have these bolts now..... I don't know the part# off hand but I called this mornig and they said that they can order them

 

Oops wrong image...

Damn if I knew you had them available I would've ordered it from you... Thanks anyway

 

Ya I just got back from my local part dept and they said it was special order only. It cost $6.74 each, but I ended up ordering through them so I can save on shipping.

I should've inquired about the USDM Mugen parts but I forgot....

 

so what about this SPC camber kit i've been hearing about? Any1?

 

I ordered the SPC camber kit for when I lower my car on the DF's. From what I found, the GE8 uses the same size bolt as the GD's. All are 14mm.

And also, a little bird whistled the hint to me.....cough Dave...cough

 

Does any one think it will be necessary to worry about camber and such with a minimal drop such as 1.2 inches like the Eibach set up will be?

 

Do this:

Drop the car (because I know for sure you want to/will), then go to a local shop and do an alignment. If they say your alignment needs special adjusting, then go ahead and order them

This way you know for sure if you need them or not