Need constant power and ignition
Thread Starter
|
New Member
Joined: Aug 2009
Posts: 16
From: San Diego
Need constant power and ignition
I have a 2009 base FIT. I am trying to install a GPS tracking device and need to tap into a continuous power supply and the ignition wire. I would like some advise on how to best do this. Any ideas?
I am thinking that the best way would be to get a wiring diagram and access via the wires in the steering column.
I also need ground, but I can get that from the chassis.
I am thinking that the best way would be to get a wiring diagram and access via the wires in the steering column.
I also need ground, but I can get that from the chassis.
Member
Joined: Dec 2008
Posts: 200
From: NSW, Australia
I have a 2009 base FIT. I am trying to install a GPS tracking device and need to tap into a continuous power supply and the ignition wire. I would like some advise on how to best do this. Any ideas?
I am thinking that the best way would be to get a wiring diagram and access via the wires in the steering column.
I also need ground, but I can get that from the chassis.
I am thinking that the best way would be to get a wiring diagram and access via the wires in the steering column.
I also need ground, but I can get that from the chassis.
Thread
Thread Starter
Forum
Replies
Last Post
Enzo3856
2nd Generation GE8 Specific Fit I.C.E. Sub-Forum
5
Sep 17, 2015 04:16 PM
Bennett0415
2nd Generation (GE 08-13)
5
Aug 17, 2012 12:24 PM
struct32
Fit DIY: Repair & Maintenance
4
Jan 3, 2009 12:12 PM
