My Fit Progress so far (lots of pics)
#1
My Fit Progress so far (lots of pics)
I got my fit on October 10, 2008, and ever since then i have done quite a few mods/upgrades to it, here some pics and what i have done. Let me know what you guys think if you have any questions and or comments ,
Interior
LED map lights
LED dome light
LED cargo light
Weather tech floor liners
OEM Cargo Cover
OEM Cargo mat
OEM center armrest (installed felt in it to make the items inside not make any rattling sounds)
Black leather w/ light gray stitching shift boot from redline goods
Mugen Shift Knob
T1R Short Shifter
20% tint all around
1UP mushroom(adds 20hp)
Electronics
Pioneer f700bt Headunit
Alpine MRP-M500 mono amp
Alpine Type S 6 1/2" speakers x 4
Alpine Type E 10" sub
Exterior
HID retrofit w/ LED
Blacked out Headlights
Nokya yellow fog lights
Mugen Grill
Mugen Front Lip
JDP Radiator cover
JDP Rear carbon diffuser
JDP Rear carbon spoiler
LED Taillights
LED License plate lights
LED parking lights
OEM Black Hood
De-badged "FIT"
Tires/wheels
SSR Type-C 17"
Bridgestone Potenza G019 Grid
Brakes
EBC Greenstuff pads
EBC slotted rotors
Suspension
Megan coilovers
SPC camber bolts
C-Pillar Bar
Engine/Exhaust
K&N Filter
T1R B-pipe
Tanabe touring medallion exhaust
Future Plans
Cusco Front strut bar
Gloss Black Vinyl
Progress rear sway bar
Maybe Plans
FA5 Civic Si Seats
If i had 10'gs laying around plan
K20 swap
and now the pics!!!
Interior
LED map lights
LED dome light
LED cargo light
Weather tech floor liners
OEM Cargo Cover
OEM Cargo mat
OEM center armrest (installed felt in it to make the items inside not make any rattling sounds)
Black leather w/ light gray stitching shift boot from redline goods
Mugen Shift Knob
T1R Short Shifter
20% tint all around
1UP mushroom(adds 20hp)
Electronics
Pioneer f700bt Headunit
Alpine MRP-M500 mono amp
Alpine Type S 6 1/2" speakers x 4
Alpine Type E 10" sub
Exterior
HID retrofit w/ LED
Blacked out Headlights
Nokya yellow fog lights
Mugen Grill
Mugen Front Lip
JDP Radiator cover
JDP Rear carbon diffuser
JDP Rear carbon spoiler
LED Taillights
LED License plate lights
LED parking lights
OEM Black Hood
De-badged "FIT"
Tires/wheels
SSR Type-C 17"
Bridgestone Potenza G019 Grid
Brakes
EBC Greenstuff pads
EBC slotted rotors
Suspension
Megan coilovers
SPC camber bolts
C-Pillar Bar
Engine/Exhaust
K&N Filter
T1R B-pipe
Tanabe touring medallion exhaust
Future Plans
Cusco Front strut bar
Gloss Black Vinyl
Progress rear sway bar
Maybe Plans
FA5 Civic Si Seats
If i had 10'gs laying around plan
K20 swap
and now the pics!!!
Last edited by strmslvrfit; 01-06-2012 at 02:42 PM.
#4
thanks!
#6
Very nice, that is definitely my style.
The only thing that bothers me is the X bar. I'd be worried about that thing bending in a crash and decapitating a rear passenger.
How is the fit and finish of your carbon fiber hood? It looks awesome in the pics.
Props for using a 10" sub. I want to put some bass in my car but I only have my 50 lb Pioneer 12" PRS and am reluctant to give it up. I bet that 10" weighs less than 20 lbs with the box?
It looks like your shift boot matches the OEM center console perfectly.
The only thing that bothers me is the X bar. I'd be worried about that thing bending in a crash and decapitating a rear passenger.
How is the fit and finish of your carbon fiber hood? It looks awesome in the pics.
Props for using a 10" sub. I want to put some bass in my car but I only have my 50 lb Pioneer 12" PRS and am reluctant to give it up. I bet that 10" weighs less than 20 lbs with the box?
It looks like your shift boot matches the OEM center console perfectly.
#7
Very nice, that is definitely my style.
The only thing that bothers me is the X bar. I'd be worried about that thing bending in a crash and decapitating a rear passenger.
How is the fit and finish of your carbon fiber hood? It looks awesome in the pics.
Props for using a 10" sub. I want to put some bass in my car but I only have my 50 lb Pioneer 12" PRS and am reluctant to give it up. I bet that 10" weighs less than 20 lbs with the box?
It looks like your shift boot matches the OEM center console perfectly.
The only thing that bothers me is the X bar. I'd be worried about that thing bending in a crash and decapitating a rear passenger.
How is the fit and finish of your carbon fiber hood? It looks awesome in the pics.
Props for using a 10" sub. I want to put some bass in my car but I only have my 50 lb Pioneer 12" PRS and am reluctant to give it up. I bet that 10" weighs less than 20 lbs with the box?
It looks like your shift boot matches the OEM center console perfectly.
#11
well the spoiler i got for $260 and the rear diffuser i believe was $250, i dont remember, its better to email him or call him, his info is on his website JDP Engineering :: Home -- "Design & Innovation with Precision"
thanks!, now im just trying to figure out how to run those wire under the carpet
thanks man!
thanks!, now im just trying to figure out how to run those wire under the carpet
thanks man!
#13
yup thats what was going for, clean and subtle. you wont regret JDP's stuff. what rims are you planning on getting?
#14
Well--I really like your rims but am worried about the offset and rubbing.
Plus, I'm a cheapo.
I'm thinking either Rota Boost or Rota Torque in HyperBlack
I can't knock Rotas--have had quite a few sets and have had zero problems.
I am getting $375 at the end of this month, and hopefully will get a $800 bonus in September. Plus, I'm saving a bit between now and then...I think that should get me the lip, spoiler and rims/tires. Then I'll actually look as good as I feel :-D
Plus, I'm a cheapo.
I'm thinking either Rota Boost or Rota Torque in HyperBlack
I can't knock Rotas--have had quite a few sets and have had zero problems.
I am getting $375 at the end of this month, and hopefully will get a $800 bonus in September. Plus, I'm saving a bit between now and then...I think that should get me the lip, spoiler and rims/tires. Then I'll actually look as good as I feel :-D
#15
Well--I really like your rims but am worried about the offset and rubbing.
Plus, I'm a cheapo.
I'm thinking either Rota Boost or Rota Torque in HyperBlack
I can't knock Rotas--have had quite a few sets and have had zero problems.
I am getting $375 at the end of this month, and hopefully will get a $800 bonus in September. Plus, I'm saving a bit between now and then...I think that should get me the lip, spoiler and rims/tires. Then I'll actually look as good as I feel :-D
Plus, I'm a cheapo.
I'm thinking either Rota Boost or Rota Torque in HyperBlack
I can't knock Rotas--have had quite a few sets and have had zero problems.
I am getting $375 at the end of this month, and hopefully will get a $800 bonus in September. Plus, I'm saving a bit between now and then...I think that should get me the lip, spoiler and rims/tires. Then I'll actually look as good as I feel :-D
#16
Wow, this may be my fave GE8 on here. I love it!
Couple of suggestions:
I have the same headunit. Get yourself one of these knobs for the volume:
http://www.avic411.com/forum/viewtopic.php?t=21115&start=0
That plastic stock knob is way to small and dinky.
BTW if you havent done so already check out that website. Has lots of cool mods for our radios. i.e newest maps, I got ride of the warning screen before the navi starts, etc..
Also maybe add the steering wheel controls using a PAC pioneer adapter.
Get some Clazzio seat covers if you like leather or vinyl. I can finally keep my seats clean
Couple of suggestions:
I have the same headunit. Get yourself one of these knobs for the volume:
http://www.avic411.com/forum/viewtopic.php?t=21115&start=0
That plastic stock knob is way to small and dinky.
BTW if you havent done so already check out that website. Has lots of cool mods for our radios. i.e newest maps, I got ride of the warning screen before the navi starts, etc..
Also maybe add the steering wheel controls using a PAC pioneer adapter.
Get some Clazzio seat covers if you like leather or vinyl. I can finally keep my seats clean
#18
Wow, this may be my fave GE8 on here. I love it!
Couple of suggestions:
I have the same headunit. Get yourself one of these knobs for the volume:
http://www.avic411.com/forum/viewtopic.php?t=21115&start=0
That plastic stock knob is way to small and dinky.
BTW if you havent done so already check out that website. Has lots of cool mods for our radios. i.e newest maps, I got ride of the warning screen before the navi starts, etc..
Also maybe add the steering wheel controls using a PAC pioneer adapter.
Get some Clazzio seat covers if you like leather or vinyl. I can finally keep my seats clean
Couple of suggestions:
I have the same headunit. Get yourself one of these knobs for the volume:
http://www.avic411.com/forum/viewtopic.php?t=21115&start=0
That plastic stock knob is way to small and dinky.
BTW if you havent done so already check out that website. Has lots of cool mods for our radios. i.e newest maps, I got ride of the warning screen before the navi starts, etc..
Also maybe add the steering wheel controls using a PAC pioneer adapter.
Get some Clazzio seat covers if you like leather or vinyl. I can finally keep my seats clean
#20
Looking good...but what's up with the pic of the open center console/armrest? Am I missing some subtle "mod" there?
Also, if you never ride with back seat passengers...then why don't you take out the rear seats? Major improvement in acceleration without seats, spare, and jack. AAA + fix-a-flat FTW.
Also, if you never ride with back seat passengers...then why don't you take out the rear seats? Major improvement in acceleration without seats, spare, and jack. AAA + fix-a-flat FTW.