PRM intake install FAIL!!!!
#1
PRM intake install FAIL!!!!
Well I tried to install my PRM intake today and my car would simply not idle. The intake is installed correctly and I checked for possible leaks and there were none. You can only mount the MAF sensor one way so that can't be it. The strangest thing is my car isn't throwing any codes, so I'm all out of ideas. Has anyone else had this issue? I have an '09 MT sport.
Last edited by bmxman; 05-21-2010 at 03:25 AM. Reason: title edit
#7
ok I just went and took it off here's a pic....as for the MAF I know some people think you can install it backwards but it only fits one way. That's why I added that in my 1st post.
Last edited by bmxman; 05-21-2010 at 02:53 AM.
#8
Pretty sure you have the pipe on backwards... look at the pic that came with the instructions. I'll check my intake in the morning to make sure.
Last edited by thefit09; 05-21-2010 at 02:56 AM.
#13
Everyone keep saying that but I have it set up exactly as the instructions say. The MAF connection should be closer to the filter. The car will start but the idle is constantly hunting for about 10 seconds then it just dies. I'll try and swap the tube around in the morning and see if that changes anything but I doubt it.
#14
yeah MAF's generally only go on 1 way, it sounds like you have a hose disconnected. but you said you checked everything...
i would suggest you put back your old one to see if it isn't a sensor failure.. BUT i know its a PAIN taking out the old intake.. because it took me forever to hall that thing out.
i would suggest you put back your old one to see if it isn't a sensor failure.. BUT i know its a PAIN taking out the old intake.. because it took me forever to hall that thing out.
#16
My PRM intake is great!
#20
yeah I tried to edit the title last night but looks like I can't edit how it except for when you actually open the thread then it says install fail...lol