2nd Generation (GE 08-13) 2nd Generation specific talk and questions here.

Question about Brakes and master cylinder

Thread Tools
 
Search this Thread
 
Old Mar 18, 2013 | 09:52 AM
  #1  
Santiad's Avatar
Thread Starter
|
Member
5 Year Member
Joined: Nov 2009
Posts: 824
From: Atlanta, Georgia
Question about Brakes and master cylinder

Morning,


A few weeks ago I swapped pads and bleed the brakes as I accidentally allowed air in. I ended up bleeding it twice because it seemed spongy but noticed not much fluid was coming out when my girl was pressing the pedal down.

The pedal feel was fine for about a month and feels good at first, but now when at a stop the pedal sinks slightly. Could this be air? a dying master cylinder?

couple of notes:

- I havent had ABS in over 2 years. My wheel sensor broke when bearings were replaced. replaced the sensors but still the light. Didnt go to Honda for fear of them making this a huge job.

-went backto DOT 3 from 4. Not sure if this afffects anything...



Need advice because this is freaking me out!
 
Old Mar 19, 2013 | 03:01 AM
  #2  
loudbang's Avatar
Banned
Joined: Feb 2013
Posts: 1,361
From: right coast
Following brake pedal is normally air in the system. Bleed them again correctly. Sounds like your helper let the pedal back up while the bleeder was still open.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jfw432
1st Generation (GD 01-08)
5
May 25, 2019 08:04 AM
MTLian
General Fit Talk
1
Jun 30, 2018 07:21 PM
MrKeishii
2nd Generation (GE 08-13)
2
Mar 12, 2014 02:03 AM
Kurse
Fit Suspension & Brake Modifications
10
Sep 25, 2009 07:33 AM
jazzplayr
Fit Suspension & Brake Modifications
2
May 12, 2007 06:37 PM




All times are GMT -4. The time now is 03:35 AM.